This truck came in on the back of a recovery vehicle complained of sticky brakes. Drove the vehicle out of yard and heard a strange noise, like a broken half shaft. Jacked up the rear and removed the wheels to discover this, we had to remove the hub assemblies, discs and pads and rene
Customer brought in the vw van, complaint of a sluggish throttle. We code read it and took of the egr valve to discover this. We reported it to the customer and they wished it to e cleaned and reassembled. Cleared the code and took for a test drive, with a noticeable difference
This vehicle was presented with a noise coming from the gearbox, when we removed the drive shafts and dump plug the oil was like silver paint, we took the gearbox out and it needed a flywheel and clutch. We sent the gearbox away for repair and the customer was very lucky. The bolts ho
This was a bit of a strange one. The customer was recommended to us by another garage. A garage who shall remain nameless, had fitted a new air con compressor and regarded the customer car. The vehicle went back to them for a noise a short time later. They then replaced the compressor
Here we have a new customer who brought his vehicle into her serviced, upon setting it up on the ramp we noticed that both his rear shockers had burst. We phoned the customer and told him this he then said ” is that why it was as bouncy” the answer was definitely YES. We r
Ththe customer came in with there vehicle complaining of a squeal/grind noise from it. We then put it on ramp and had a look to discover they had ran out of pad and it had slipped through the carrier. A quick fix new calliper and discs and pads, then the vehicle was good to go.
We had to laugh when we seen this. After speaking to the customer, he decided, rather than bother us on a Friday, he would strip and make his own pads, out of wood. It must have took him longer to make it than bring it down to get sorted. So a pair of discs and pads later, we had it s
Complaint of air con not working, we leak tested it and discovered that the condenser was leaking. We stripped the front end of the vehicle to discover some accident damage was what had caused it. We fitted a new condenser and front panel, straightened out the bumper and delivered it